Spraying Techniques - Storch PowerCoat Mode D'emploi

3. Screw the nozzle mount and nozzle onto the spray
device. Tighten the nut manually until it is screwed onto
the spray device completely.
Spray technique
Practice spray technique on a piece of cardboard prior to coating the intended surface.
25 cm
consistent
application
Direct the spray device straight at the target surface from a distance of approx. 25 cm. Angling the deviceto change the
direction of spray will cause uneven application.
NOTE:
the speed at which the spray gun is moved influences the quantity of material applied. In case the spray stream pulses,
you are moving the device too quickly. If the material runs out, you are moving the device too slowly.
Movement process
Pull the trigger after beginning movement. Release the
trigger prior to ending movement. The spray device must
be moved when the tirrger is pulled and released.
thick
thin
uneven
application
The nozzle is attached firmly on the nozzle mount. It may
not be removed, since this could cause damage.
consistent
application
Directing the spray stream
Overlap the previous spray stream 50%.
109
thin thick thin