Storch PowerCoat Mode D'emploi page 107

5. If the pistol has been rinsed, lock the trigger safety lock
and place the ventilation/discharge valve in the upwards
position (UP) to discharge the pressure.
Materials
To process water-based materials, rinse the device thoroughly with water. If you spray with solvent-based materials,
then rinse the device thoroughly with a compatible solvent.
Refilling the material hopper:
1. Lock the trigger safety lock and place the ventilation/
discharge valve in the upwards position to discharge the
pressure.
3. Release the trigger safety lock and press the on/off
switch for approx. 10 seconds to ventilate the pump.
Release the trigger and place the ventilation/discharge
valve downwards in the spray position.
6. Unscrew the material hopper.
7. Release the trigger safety lock, place the ventilation/
discharge valve into the downwards position, hold the
spray device close above the material hopper, and then
press the trigger to discharge the fluid from the pump.
2. Equip the hanging container with a container insert,
fill the container with material and screw it onto the the
spray device.
4. Direct the spray device into an empty container, turn
the nozzle into the cleaning position (arrow to the rear)
and press the on/off button for approx. five seconds.
Return the nozzle to its position in the spray position.
NOTE:
f this process is not completed, the spray pattern may be
impaired.
107