Inlet Pipe; Processing Low-Viscosity Media - Storch PowerCoat Mode D'emploi

Inlet pipe

This spray device features two different intake pipes.
Standard intake pipe
walls: when spraying walls, turn the intake pipe to the
front.
Special intake pipe
ying floors, turn the inlet of the intake pipe towards the
front side of the material hopper (the nozzle).

Processing low-viscosity media

The diffusor reduces the flow of low-viscosity media so that a finer spray pattern may be achieved.
Installation:
1. Remove the material hopper and the intake pipe.
for spraying ceilings and
for spraying floors: when spra-
When spraying ceilings, the intake tube's inlet should be
turned toward the rear of the material hopper (the trig-
ger).
NOTE:
If the spray device is angled too severely, air will be
sucked in and material will not be sprayed.
2. Insert the diffusor (without cleaning needle) for viscoe
material into the pump inlet until it snaps in completely,
then replace the intake pipe.
3. Cleaning/storage
The diffusor for low-viscosity media should be removed
immediately after use and cleaned. Store the diffusor in
the provided storage/cleaning tool so that is cannot be
clogged with dried material.
105