Components - Meister MPH1400-1 Traduction Du Manuel D'utilisation Original

5452820-Bohrhammer_man 12.02.18 12:19 Seite 45
Noise emission
Sound level:
Hammer drilling:
L : 95.74 dB(A), K
pA
Sound power level:
Hammer drilling:
L : 106.74 dB(A), K
WA
Noise/vibration information
Measured values determined in
accordance with EN 60745-1,
EN 60745-2-6.
• The specified vibration emission
value was measured in
accordance with a normed test
procedure and can be used in
order to compare one power tool
with another.
• The specified vibration emission
value can also be used for an
introductory evaluation of the
exposure.
• The vibration emission value may
fluctuate from the specified value
during actual use of the power
tool. These fluctuations will
depend on the way in which the
power tool is used.
In order to prevent the risks caused
by vibrations,
• Wear gloves when using;
• Limit working times and shorten
the actual operating time.
: 3 dB(A)
pA
: 3 dB(A)
WA
Safety measures must be
taken in order to protect the
operator. As a result, the
evaluation of the influence
must be made whilst taking
account of the actual
conditions of use. (All parts of
the operating cycle must be
taken into account for this
purpose. This also includes
times in which the power tool
is switched off and times in
which it is switched on, but is
running without load.)
CAUTION! A certain
amount of noise is
unavoidable when using
this device. Ensure you carry
out noise-intensive work
during permitted times.
Maintain the quiet periods and
limit your work to the absolute
minimum.
CAUTION! The effects of
noise may cause
damage to the hearing.
Only ever work with suitable
ear defenders. Anybody else in
the vicinity should thus also
wear ear defenders.
3 – Components (Figure 1/2)
1 On/Off switch
2 Handle
3 Additional handle
4 Clamp opening
5 Tool holder
5a Holder sleeve
6 Depth stop
45