Quick Start - HBM PMX Manuel D'emploi

Quick Start

10 Quick start
1. Connect the PMX to a PC via the Ethernet socket.
Cable: Standard Ethernet cable (Cat−5)
2. Connect your transducers to the measurement cards (plug terminals)
(see Sections 7.3 to 7.6)
e.g.
PX455
Note: The transducers can also be connected if you have previously connec-
ted the voltage supply
3. Connect the voltage supply (10 ... 30 V DC)
(see Section 7.2)
The PMX boots, and then displays its system status. (see Section 7.1.1). The
system LED must show green. This process takes a few seconds.
At least 15 W of power must be supplied.
A3257−2.0 en/de/fr
Á Á
wh
Measurement signal (+)
bk Bridge excitation
voltage (−)
rd
Measurement signal (−)
bu
Bridge excitation
voltage (+)
gn
Sense lead (+)
gy
Sense lead (−)
ye
Cable shield
Hsg.= housing
+
−
Á Á Á Á
81
1
2
4
3
'
3
'
2
Hsg.