HBM PMX Manuel D'emploi page 472

136
ACL
Enable (default) or disable automatic start of calibration of all selected
channels (PCS / SPS) . Calibration is then done if sensor is plugged or
measurement signal has been in overflow for a few seconds. Only supported
for PX455 !
Syntax: ACLp1(x)
Parameter:
Note: If on (enabled), autocal is enabled for bridge or bridge­like
sensors (poti / lvtd).
Response depends on SRB command.
ACL?
All selected channels (PCS / SPS). Only supported for PX455 !
Syntax: ACL?(x)
Response: q1(y):
e.g. 0,0,0,0:1,1,1,1:0,0
Enable / Disable Autocal
p1 Autocalibration
0 Off
1 On
Enable / Disable Autocal Query
q1 Autocalibration
0 disabled
1 enabled
Jeu de commandes
A3257−2.0 en/de/fr