HBM PMX Manuel D'emploi page 112

112
PCS
This command performs channel selection for the immediately following setup
commands.
Syntax: PCS p1,.., p16 (x)
Parameter: p1,.., p16 channels
PCS 0 (x) selects all the existing channels
Initially all channels (boards) are selected.
If one channel (board or slot) is not available, this channel will be ignored and
will not be added to the list
PCS(x) clears all selected channels(boards/slots). After that PCS?1 only re-
turns (x).
Note: Response depends on SRB command.
PCS?
Syntax: PCS? p1(x)
Parameter: p1:
0 existing channels
1 selected channels
Responsee: q1,.., q16 list of existing or active channels
PCS?0 equals PCS?
Initially all available subchannels (signals) are selected.
Programming Channel Select
Channel selection for setup commands
Programming Channel Select Query
Output channel selection for set-up commands
output mode
Commmands
A3257−2.0 en/de/fr