Configuration Of The Keys - Alfa Laval TopControl Basic Manuel D'utilisation

7.3. configuration of the keys
The configuration of the 2 keys varies depending on the operating status (AUTOMATIC / MANUAL).
The description of the operating statuses (AUTOMATIC / MANUAL) can be found in the chapter entitled "7.1.
Operating status".
Version 1
Key 1
Key 2
Figure 10: Description of the buttons
→
To operate the buttons, for
Version 1:
Version 2:
MANUAL operating status (DIP switch 4 set to ON):
Key Function
Aerate
1
(manually open / close the actuator)
Deaerate
2
(manually open / close the actuator)
Table 6: Configuration of the keys for MANUAL operating status
AUTOMATIC operating status (DIP switch 4 set to OFF):
Key Function
1 Press for 5 seconds to start the X.TUNE function
2 -
Table 7: Configuration of the keys for AUTOMATIC operating status
No function if the binary input was activated with the "Manual/Auto change-over" via the communications
7)
software
Depending on the operating principle of the actuator.
8)
26
unscrew the body casing
unscrew the transparent cap
7)
7)
English
Version 2
Key 1
8)
8)
Type 8694
Control and display elements
Key 2