Alfa Laval TopControl Basic Manuel D'utilisation page 54

→
To operate the buttons and DIP switches, for
Version 1:
Version 2:
Version 1
Figure 37: Automatic adjustment X.TUNE
→
Start the X.TUNE by pressing button 1
While the X.TUNE is running, LED 1 flashes quickly (green).
When the automatic adjustment is complete, LED 1 flashes slowly (green)
The changes are automatically transferred to the memory (EEPROM) provided the X.TUNE function is successful.
important: When the X.TUNE function is activated, the actuator cannot be actuated via the AS-Interface
communication.
Figure 38: Position of the seal in the body casing
→
Version 1: Check that the seal is correctly positioned in the body casing.
noTe!
damage or malfunction due to penetration of dirt and humidity!
• To observe protection class IP65 / IP67, screw the transparent cap in all the way.
→
Close the device (assembly tool: 674077
The X.TUNE can also be started via communications software.
20)
If a fault occurs, LED 1 is lit red.
21)
The assembly tool (674077) is available from your Bürkert sales office.
22)
54
unscrew the body casing
unscrew the transparent cap
20) for 5 s.
22)
English
LED 1
LED 2
LED 1
Key 2
Key 1
LED 2
DIP Switches
Communications
interface
Key 1
Key 2
Body casing
Seal
body casing
).
Type 8694
Start-up
Communications interface
ON DIP
1 2 3 4
.
21)
Version 2