Connecting Spool Gun To Millermatic 211 Auto-Sett - Miller Spoolmate 150 Manuel D'utilisation

3-4. Connecting Spool Gun To Millermatic 211 Auto-Sett

6
1
3
7
.
Be sure that gun end is tight against drive assembly.
Incorrect
Exposed O-rings
will cause shielding
Gun Not Seated
5
4 2
4
Gun Fully Seated
gas leakage.
1 Drive Assembly
2 Spool Gun
3 Gun Securing Knob
4 Gun End
Loosen thumbscrew. Insert end
through opening until it bottoms
against drive assembly. Tighten
gun securing knob.
Spool gun must be inserted
completely to prevent leakage of
shielding gas.
5 Gun Trigger Plug
Insert plug into receptacle, and
tighten threaded collar.
6 Polarity Changeover Terminal
Block
To make proper polarity connection,
see welding power source Owner's
Manual .
7 MIG Gun/Spool Gun Switch
Place switch in Spool Gun position.
Close door.
4
Correct
Ref. 804 984-A / Ref. 805 390-A / Ref. 801 987
OM-272 384 Page 13