Section 4 − Operation; Controls For Millermatic 211 - Miller Spoolmate 150 Manuel D'utilisation

4-1. Controls For Millermatic 211

OM-272 384 Page 16
SECTION 4 − OPERATION
4
2
1
3
6 5
1 Shielding Gas Cylinder
For shielding gas connections, see
welding power source Owner's
Manual.
2 Valve
Open valve on cylinder just before
welding.
Close valve on cylinder when
finished welding.
3 Process Select Switch
Select the Spool Gun position.
4 Trigger
Press trigger to energize welding
power source contactor, start
shielding gas flow, and begin wire
feed.
5 Wire Feed Speed Control
Wire feed speed is controlled by
welding power source Wire Speed
control (see welding power source
Owner's Manual or door chart for
appropriate setting).
6 Voltage Control
Arc voltage is controlled by welding
power source Voltage control (see
welding power source Owner's
Manual or door chart for appropri-
ate setting).
.
To purge shielding gas line,
hold trigger for three seconds.
sb5.1* 6/92 − S-0621-C / Ref. 265 381-A / Ref. 271 714-A