Controls For Multimatic 200 - Miller Spoolmate 150 Manuel D'utilisation

4-3. Controls For Multimatic 200

4
OM-272 384 Page 18
2
1
3
1 Shielding Gas Cylinder
For shielding gas connections, see
welding power source Owner's
Manual.
2 Valve
Open valve on cylinder just before
welding.
Close valve on cylinder when
finished welding.
3 Process Switch
Turn process switch to MIG ALU-
MINUM (Spool Gun).
4 Trigger
Press trigger to energize welding
power source contactor, start
shielding gas flow, and begin wire
feed.
5 Adjust Knobs
Voltage and wire feed speed are
controlled by welding power source
adjust knobs (see welding power
source Owner's Manual or door
chart for appropriate setting).
5
sb5.1* 6/92 − S-0621-C / Ref. 235 125-B / Ref. 804 986-A