Section 3 − Installation; Specifications; Removing Mig Gun From Welding Power Source - Miller Spoolmate 150 Manuel D'utilisation

3-1. Specifications

Wire Feed Speed
Wire Diameter Range
.030 Thru .035 in.
(0.8 Thru 0.9 mm)
Aluminum Wire
Or Flux Cored Wire
(0.13 To 17.8 mpm)*
.023 Thru 035 in.
(0.6 Thru 0.9 mm) Solid
Wire
*Actual wire feed speed range will vary depending on welding power source.

3-2. Removing MIG Gun From Welding Power Source

Turn Off Power
.
Hold wire tightly to keep it
from unraveling.
Rewind Wire Onto Spool, Fasten
End Of Wire To Spool
SECTION 3 − INSTALLATION
Cooling
Range Method
5 to 700 ipm*
Air Cooled
Cut Off End Of Wire
Maximum Weld Circuit
Spool Size Rating
22.5 Volts, 135
Amperes, 30%
4 in. (102 mm)
Duty Cycle
Diameter
Using Argon
Shielding Gas
Knob
Loosen Knob, Disconnect Gun Trigger
Plug, And Remove Gun From Unit
(See Section 3-3 for gun installation)
270 208-A / Ref. 802 982-A / Ref. 267 805-A / Ref. 267 807-A
Overall Dimensions Weight
Length:
13 in. (330 mm)
Width:
5.6 lb (2.54 kg)
2-1/4 in. (57 mm)
Gun With Cable
Height:
8 in. (203 mm)
Open Pressure Assembly
OM-272 384 Page 11