Harvia HWS1500EU Instructions D'installation Et D'utilisation page 30

EN

To the steam generator
Water softener
Remove the plastic film around the pre-filter, and install it in the notch on the bottom of the pre-filter
•
housing.
Rotate the pre-filter housing and its cover together.
•
Check the direction of water flow from the arrows on the pre-filter housing cover. The flow direction
•
should be towards the water softener. Install the wall bracket with screws to the pre-filter taking the
flow direction into account.
Attach the pre-filter assembly to the wall / rack.
•
Attach 1 m long water hose between the pre-filter and the "Hard water" connector on the back of
•
the water softener. Also check the arrows on the pre-filter and water softener for correct water flow
direction. Use the ¾ " double nipple at the end of the pre-filter as a mounting aid.
Attach 1.5 m long hose between the "Soft water" connector on the back of the water softener and
•
steam generator. Check the arrows from the water softener for correct water flow direction.
Open front cover of the water softener, then open two fixing screws behind back cover and carefully
•
lift back cover without damaging the internal electrical wiring.
Attach the white drain hose to the drain connector under back cover with a clamp.
•
Connect the adapters' connector to the displays' connector inside of the back cover.
•
Close the back cover.
•
Attach a hose between inlet water and pre-filter, if needed use a ¾ "double nipple (hose not included).
•
Add about 15 cm layer of salt tablets (salt sold separately) to the water softener tank.
•
Close the cover.
•
Carefully open the inlet water and check for leaks everywhere.
•
Connect the water softener to electrics with the transformer.
•
Read more detailed instructions on programming the water softener and pre-filter in this manual.
30
¾" Reinforced hose
1,5 m
¾ " double nipple,
2 pcs
Pre-filter
DE
¾" Reinforced hose
1 m
Drain hose
To the drain
Wall bracket
Pre-filter housing cover
Pre-filter housing
Transformer
EU/UK/US
Inlet water