After Use; Cleaning And Maintenance - Meister MAS18MZ Mode D'emploi

Direction of rotation, right/left
(Figure 7)
The direction of rotation is deter­
mined­using­the­"Right/Left"­switch­
(4) above the power switch.
CAUTION! The direction of
rotation may only be changed
when the motor is at a standstill!
•­ Installing­screws:­Set­the­right/left­
switch (4) to right rotation.
•­ Removing­screws:­Set­the­right/
left switch (4) to left rotation.
•­ Safety­position:­Centre­switch­
position; with the sliding switch in
this position, the machine cannot
be operated. Use, for example,
when taking a break or changing
bits or drills.
CAUTION! Risk of over winding
caused by screwing screws in
too deep. Watch the screwing pro­
cess carefully and, if necessary,
stop early and finish the process
with an ordinary screwdriver. Carry
out test installations!
Gear switch (Figure 8)
Using the gear switch (3) you may
select­two­different­revolution­rang­
es.
•­ Switch­position­1:
0 – 400 min
removing screws
•­ Switch­position­2:
0 – 1500 min
screws and drilling
The revolution range to be selected
68
is determined by the relevant mate­
MW-5451340-Bedien-1908.indd 68
­1 for installing and
for installing
­1
rial and the intended task and
should be tested using a test piece.
CAUTION! Only switch over
when the motor is at a stand­
still.
11 – After use
•­ Release­the­On/Off­switch­to­
switch­the­machine­off.
•­ Set­the­left/right­rotation­to­the­
middle position to block the On/
Off­switch­and­prevent­uninten­
tional activation of the machine.
•­ Remove­the­rechargeable­battery­
and the tool before you clean and
store the machine.
•­ Clean­the­machine­as­described­
under­"Cleaning­and­maintenance".­
12 – Cleaning and mainte­
nance
Cleaning
CAUTION! Electric shock!
WARNING! Risk of electric
shock!
•­ Wait­until­the­machine­has­cooled­
down and remove the rechargeable
battery from the machine.
•­ Before­cleaning­the­charger,­
always pull the plug out.
•­ Make­sure­that­no­water­is­able­to­
enter the machine.
•­ Do­not­damage­the­surfaces­of­
the machine.
12.09.19 08:44