How To Use - Meister MAS18MZ Mode D'emploi

accessories by hand quickly and
without a chuck key.
•­ Open­the­claws­of­the­quick­ac­
tion chuck. To do this, rotate the
quick­action chuck anti­clock­
wise. Open the quick­action
chuck far enough to be able to
insert the tool.
•­ Insert­the­tool­in­the­quick­action­
chuck.
•­ Rotate­the­quick­action­chuck­
clockwise and tighten securely.
CAUTION! Accidentally
switching the machine on is
an injury risk. Set the switch for
the rotation direction to the mid­
dle setting when the machine is at
a standstill in order to activate the
lock for the On/Off switch.
CAUTION! Risk of cuts.
• Wear gloves to insert a drill into
the quick­action chuck.
• Tighten the quick­action chuck
to clamp the tool in place.
The chuck of right/left rotat­
ing machines is always fixed
with a left­threaded screw. This
must be loosened from the front
through the chuck (1) before
changing it. Left­threaded screws
can only be loosened by turning
to the right.
Switching on and off (Figure 7)
•­ ­ S witching on:
Press­the­On/Off­switch­(11).­The­
screwing/drilling process starts.
During the screwing/ drilling pro­
MW-5451340-Bedien-1908.indd 67
cess, keep the switch pressed.
The LED working light (10) will
light up.
•­ ­ S witching off:
As soon as the screw or drill has
been screwed in or removed fully,
release­the­On/Off­switch.­The­
screwing or drilling process is
completed, and the LED working
light will go out.
LED working light (Figure 6)
When the machine is switched on,
the LED working light (10) is lit to
provide better vision and to enable
safer work in darker areas. The LED
working light goes out when the On/
Off­switch­is­released.
CAUTION! LED working light!
Do not look directly into the
beam of light as this may result in
damage to the eyes.
10 – How to use
Electronic revolution regulation
The electronic revolution regulation
can be achieved by adapting the
revolutions steplessly to the process
you are using.
•­ A­light­pressure­on­the­On/Off­
switch (11) = Low revolutions to
undo stubborn screws.
•­ Push­down­fully­on­the­switch­=­
Highest revolutions to drill with.
CAUTION! When drilling or
using as a screwdriver, avoid
the motor coming to a standstill
under load!
67
12.09.19 08:44