Appendix 1; Display Rotation - Burkert SE 56 Manuel D'instructions

Fixing screw
of board
Unscrew the screws suitable in pic. 1
Lift the board, disconnect the flat cable
from the display (pic. 2) and completely
remove the board from the box
4 allen spanners
Unscrew the fixing screw of the display to
allow the bracket to be shifted and the
display to be removed.
N.B.: do not entirely unscrew the screw

APPENDIX 1

Display rotation

Pic.1
Take off the
flat cable
Pic.2
Display
Pic.3
1
Pic.4
3
2
Rotate the display in the desired position,
ensure the seal is correctly fitted and the
contact surfaces are clean, then insert the
display in the lodging.
Shift the bracket in the suitable direction (pic. 5)
and fasten the screw
Fasten the screws in an alternating pattern (1-
2-3-4) (pic. 4).
Pic.6
Connect the flat cable back to the display
Verify the correct set of the board in the fixing
clip ( Pic.7 )
Finish the assembling by screwing the
boardback to the box.
38
SE 56
Pic.5
4
Display
Pic.7