Burkert SE 56 Manuel D'instructions page 22

(functions with symbol "*" are detailed at page 27 and following)
Attention
: The functions in grey are visualized on the display only with other active
functions or with optional modules
SE56 Functions
1.1 Enter the Nominal Diameter on sensor label (0-3000 mm)
1.2
Calibration data of sensor visualized on sensor label
1.3
Type of sensor: Enter the first two characters of the sensor serial number (sensor label)
1.4 NOT USED
1.5 F
actory parameter
1.6
Length of the cable connecting the sensor to the transmitter (with preamp module)
1.7
Enables the empty pipe detection feature
1.8*
Enables the automatic zero calibration system
1.9*
Enables the automatic calibration procedure of the empty pipe detection
2.1*
Full scale value set for range N.1
2.2* Full scale value set for range N.2
2.3* Measuring Unit and number of decimals for the totalizers
2.4* Pulse value on transistor output 1
2.5* Pulse value on transistor output 2
2.6* Duration of the pulse generated on transistor output 1
2.7* Duration of the pulse generated on transistor output 2
2.8 Full scale freq. for channel 1 (0.1Hz-1000.0Hz) (0.1Hz-10000Hz with optional module)
2.9 Full scale freq. for channel 2 (0.1Hz-1000.0Hz) (0.1Hz-10000Hz with optional module)
2.10
Enable/disable the selection of mass units on full scale set
2.11 Specific gravity set in kg/dm³
3.1* Time constant
3.2
Filter on the power supply: 0.1s="ready" measure; 0.5s=filter of noise on the liquid
3.3*
Acceleration threshold
3.4*
Anomalous signal peak cut off threshold
3.5
Low flow zero threshold: 0-25% of full scale value
3.6
Enable every hour an internal cycle of calibration. The measure is stopped for 8-15 sec.
3.7*
Automatic change of scale
3.8*
Energy saving
4.1 Percentage of the max. direct flow rate at which an alarm is generated
4.2
Percentage of the max. reverse flow rate at which an alarm is generated
4.3 Percentage of the min. direct flow rate at which an alarm is generated
4.4
Percentage of the min. reverse flow rate at which an alarm is generated
4.5
Hysteresis threshold set for the minimum and maximum flow rate alarms
4.6
Empty pipe detection threshold. Automatically set by function 1.9
4.7*
Current output value in case of failure
4.8*
Frequency output value in case of failure
4.9* Batch safety timer
21
SE 56