Table Des Matières - Burkert SE 56 Manuel D'instructions

TABLE OF CONTENTS
Introduction ___________________________________________p.3
Symbol Used on the manual ________________________________________ p.3
Technical characteristics ________________________________p.4
Electrical characteristics ___________________________________________ p.4
Environmental conditions of use _____________________________________ p.4
Operating temperature_____________________________________________ p.4
Overall dimensions _______________________________________________ p.5
Grounding instructions _____________________________________________ p.6
Transmitter power supply___________________________________________ p.6
Electrical connections _____________________________________________ p. 7
Terminal block M1 for compact, wall-mounted and panel-mounted versions ___ p.7
Electrical connections sensor-transmitter ______________________________ p.8
Inputs/outputs _________________________________________p.9
Optional modules (except relay modules) ______________________________ p.9
Optional relay modules ____________________________________________ p.10
Input ___________________________________________________________ p.11
On/Off output wiring (up to 1250 Hz) - low frequency _____________________ p.15
On/Off output wiring (up to 12500 Hz) - high frequency ___________________ p.15
Analogical output - 0\4÷20 mA ______________________________________ p.15
Start up and maintenance of the devices __________________ p.16
Programming the device________________________________ p.17
Transmitter visualization pages _____________________________________ p.17
Transmitter visualization pages with currency enabled ____________________ p.17
Flags interpretation and led _________________________________________ p.18
Transmitter key board _____________________________________________ p.19
Transmitter menus _______________________________________________ p.20
Access the configuration menus _____________________________________ p.21
Access codes____________________________________________________ p.26
Block levels _____________________________________________________ p.26
Programming functions ________________________________ p.27
Batch _______________________________________________ p.35
Enable batch ____________________________________________________ p.35
Programming batch _______________________________________________ p.35
Start / stop batch _________________________________________________ p.36
Important notes __________________________________________________ p.36
Alarm messages ______________________________________ p.37
Causes and actions to be taken______________________________________ p.37
error codes _____________________________________________________ p.37
Display rotation _______________________________________ p.38
APPENDIX 1
2
SE 56