Burkert SE 56 Manuel D'instructions page 23

5.1* Total direct (positive) flow totaliser reset enabling
5.2*
Partial direct (positive) flow totaliser reset enabling
5.3*
Total reverse (negative) flow totaliser reset enabling
5.4* Partial reverse (negative) flow totaliser reset enabling
5.5
Reset above totalisers set to "ON", through pulse from input 1 (see page 12)
5.6
Totaliser counting lock command (see page 12)
5.7*
Autozero calibration through external command
5.8
Range change through external command (see function 3.7)
5.9
Batch start/stop through external command (see batch functions)
5.10* Functions assigned to input 2
6.1* Output 1 functions
6.2* Output 2 functions
6.3* Output 3 functions
6.4* Output 4 functions
6.5* Duty cycle value for pulses/frequency output
6.6* Choice of the function and the range of current output n.1
6.7* Choice of the function and the range of current output n.2
7.1
Choice of the communication protocol for the IF2 device
7.2
Choice of the communication protocol for the RS232 port
7.3
Address value of converter (range 0 – 255)
7.4
Speed of the RS485 output (possible choices: 2400, 9600, 19200, 38400 bps)
7.5
Speed of the RS232 output (possible choices: 2400, 9600, 19200, 38400 bps)
7.6 Print function enabled (optional)
7.7 Print of the performed batch
7.8 Print of the data at regular intervals
7.9 Print of the process events on regular intervals
7.10
Address of a further transmitter connected like a terminal
7.11
Start remote connection to the terminal. Connection interrupted after 10sec. of inactivity
8.1
Choice of the language: E= English, I=italian, F= French, S= Spanish
8.2
Updating frequency on the display: 1-2-5-10 Hz
8.3*
Display contrast
8.4
Partial totalizer visualization (with batch enable the function is always on)
8.5 Date and time visualization with data logger enable
8.6
Quick start menu visualization
8.7
Enable the change value of the totalizers (see function 5.1-5.4)
8.8*
Enable the page of net totalizer (difference between direct and reverse. see page 17)
8.9
Reset the display processor (in case of particular bad operation of the display)
8.10
Visualizes the values of the partial totalirer in the unit of selected currency
8.11
Choice of the numbers of decimals for the visualization currency value: From 0 to 3
8.12*
Value of conversion/currency for direct totalizer
8.13*
Value of conversion/currency for reverse totalizer
22
SE 56