Start Stop Batch; Important Notes - Burkert SE 56 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

START: it is possible to activate the start of batch in two different ways:
from a remote input: assigning the functions of start/stop batch to input 1 (POS. 5.9) or
input 2 (POS. 5.10) and using the input/s like visualized at page 12 and following.
from the keyboard: short press of "UP" key.
N.B.: the start of batch from keyboard is always on the descent front (release of the key) and
is not available with the function of batch consent (POS. 12.7)
STOP: the stop of batch can be due to three events:
keyboard or remote input (manual stop): short press on key
end of batch: in this case the stop of batch will be activated from an output signal as
soon as the batch quantity is reached.
maximum time of batch: if a maximum batch time has been set and this is exceeded,
the batch in progress is stopped independently from the batched quantity
Notes:
during the batch the symbol of the active batch
visualized on the display.
When the batch outputs are enabled, pushing "UP" key for more than 5 sec. causes the
outputs to remain energized till the key is released. On the display, in place of the CT and ST
totalisers the following messages will appear:
The start of the batch disables any function listed below:
* IF INPUT 1 IS USED
** VALUE SET TO ZERO
POS 12.5
AUTO BATCH
POS 12.6
BM AUTO SEL
POS 12.7
CONS. MODE
INPUT 1 ON START/STOP
POS 5.9
BATCH
INPUT 2 ON START/STOP
POS 5.10
BATCH
POS 5.10
BM SELECT
POS 6.1÷6.4
OUTPUT ON END BATCH
To optimize the performances of the transmitter used as a batch instrument, it is recommended to set it
as prompt as possible according to the plant requirements, choosing the opportune values of time
constant (pos. 3.1) and acceleration threshold (pos. 3.2).

START STOP BATCH

!! VALVE !!
!! OPENED !!

IMPORTANT NOTES

POS 12.5
POS 12.6
POS 5.6
*DISABLE
DISABLE
DISABLE
* DISABLE
DISABLE
36
and the name of the formula are
POS 12.1
POS 5.9
POS 3.7-5.8
** DISABLE
DISABLE
DISABLE
DISABLE
** DISABLE
disables
SE 56
POS 3.8
POS 5.7
DISABLE
DISABLE
DISABLE
DISABLE
DISABLE

Publicité

Table des Matières
loading

Table des Matières