Burkert SE 56 Manuel D'instructions page 24

9.1*
Date and time set
9.2
Automatic data logger enable
9.3
Interval time for the data logging function: 1, 2, 3, 6, 8, 12, 24, 48 hours
9.4
Displaying of the data stored in the data logger
9.5 Displaying of the last 64 alarms stored in the data logger
9.6
Visualization function of minimum and maximum peak of flow rate
9.7
Logged data cancel function
9.8
Reset all alarm events
9.9
Reset all minimum and maximum peak of flow rate stored
10.1*
Enable the calibration of the converter
10.2*
Converter autotest
10.3*
Flow rate simulation enabling
11.1
Level 2 access code enter
11.2
Block level function can be set from 0 to 3
11.3
Load factory data pre-set
11.4
Load user data saved
11.5
Save user data
11.6
Visualisation of the total operation hours of the converter (function not editable)
11.7 Ignore the calibration error during the switch on test
11.8 Ks Coefficient
Menu 12: Menu visualized only with batch active
(see page 35 and following)
12.1
Number of batch cycles to be done to define the value of compensation. Value 0=OFF
12.2*
% limit of compensation threshold
12.3*
Compensation value
12.4*
Prebatch value
12.5* Auto-batch
12.6*
Automatic selection of batch formula
12.7*
Static consent of batch
23
SE 56