Burkert SE 56 Manuel D'instructions page 13

INPUT OPERATION STAGE (GENERIC FUNCTIONS)
Auto-calibration
AUTOCALIB. OFF
3-40 V
0-1,5 V
T
Reset totalizers
BLOCK
3-40 V
0-1,5 V
T
Hold totalizers
Hold totalizers
3-40 V
0-1,5 V
Totalizers active
Range change
3-40 V
0-1,5 V
Speed rate
10 Hz
20 Hz
50 Hz
80 Hz
150 Hz
N.B.: THE FUNCTIONS INDICATED ABOVE ARE ONLY ENABLED ON INPUT 1
OPERATION ON INPUT ON/OFF
RESET
Tmin = 100ms
Scale 2
Scale 1
Tmin
220 ms
110 ms
45 ms
30 ms
15 ms
Tmin<T<1sec. = autocalibration
T > 1 sec. = Auto zero
Necessary conditions for enabling the function
POS. 5.7 ON
POS. 5.9 (batch on input 1) OFF
POS. 5.10 batch functions assign to input 2
(optional) OFF
Necessary conditions for enabling the function
POS. 5.1 ÷ 5.4 ON, at least one
N.B.: This function is also assignable to
input 2
Necessary conditions for enabling the function
POS. 5.6 ON
POS. 12.5 (auto-batch) OFF
POS. 12.7 (batch consent) OFF
Necessary conditions for enabling the function
POS. 5.9 (batch on input 1) OFF
POS. 5.10 batch functions assign to input 2
(optional) OFF
POS. 6.1-6.4 end-batch functions assigned
to output 2 OFF
POS. 5.8 ON
ATTENTION: time T
must be ≥ Tmin
12
SE 56