Battery Charging On First Use - Stiga Autoclip M3 Manuel D'utilisation

5. Fasten the charging station (N) to the ground with the pegs (P).
If necessary, secure the charging station with screw anchors
(Q).
EN
6. Install the power supply unit (A).
7. Connect the power cord (E) of the charging station (N) to the
power supply unit (A).
8. Connect the plug of the power supply unit (A) to the electrical
outlet.
9. If the LED of the transmitter flashes, the connection is correct.
Otherwise, find the anomaly (see "Troubleshooting Guide").
10. Replace the protection (L).
1. Place the robot inside the charging station.
2. Press the ON/OFF key and wait a few seconds for the robot to
turn on completely.
3. The battery LED turns orange and remains fixed for a few
seconds during recognition of the charging station.
4. Make sure the AUTO LED is off, if necessary press the AUTO
key to turn it off.
5. At the end of charging, the robot can be used or programmed
for initial start-up (see "Programming Mode").
Important
On first use, always charge the batteries for at least 4 hours.
User's manual

BATTERY CHARGING ON FIRST USE

18
pegs (P)
charging station (N)
transmitter (T)
H. min. 160 cm
(63.00 ")
power cord (E)
charging station (N)
STOP
"PLAY/PAUSE" KEY
START / PAUSE
"ON" KEY
AUTO
ON / OFF HOME
AUTO ALERT
screw anchors (Q)
current power
supply unit (A)
Perimeter
wire
protection (L)