Service Data - SICK T&D PBS Mode D'emploi

Operating Instructions

Service Data

IO-Link-specific
Index
Name
(dezimal)
16 Vendor Name
17 Vendor Text
19 ProductID
21 Serial Number
Application Specific
24
Name
33 Last Event
40 ProcessDataIn
243 OrderNo
SICK-specific
Index
Name Format
(dezimal)
SP1/ 16 Bit
65
FH1 unsigned
40 © SICK AG • Germany • All rights reserved • Subject to change without notice 8013154/U275/2010/02/01
7. Starting, operation
Format Access Example
R SICK AG
Sensor
R
Intelligence
8 x 8Bit R 6038664
8 x 8Bit R
16 x 8Bit R/W
8Bit + 16Bit R
16Bit R
R
Access Range
R/W 1040-9000
Range Remark
Refer to IO-Link specification.
Refer to IO-Link specification.
Refer to IO-Link specification.
This SPDU refers to the corresponding IODD. It corre-
sponds to the virtual order number of the entire product
family.
Production ID of the SICK pressure switch. It contains
alphanumeric characters.
The text can be defined by the user. It serves as identifica-
tion of the pressure switch within a network.
Refer to IO-Link specification.
This SPDU reflects the process data as they are also
cyclically transmitted (see above).
In contrast to the ProductID this SPDU refers to the actual
order number of the pressure switch.
Remark
Corresponds to the process value at which the switch is activated (closed,
Q +24 V) or to the upper limit in the window mode. In case of the output
being parametrized as „Hnc" or „Fnc" (normally closed), the logic is
inverted. The value of RP1 / FL1 shall be at least 40 units (0,5 % of the
measuring range) lower than the value of SP1 or FH1, respectively. If this
is not the case, RP1 or FL1 are set to the nearest possible value.
PBS