Packaging; Starting, Operation - SICK T&D PBS Mode D'emploi

Operating Instructions

6. Packaging

Has everything been supplied?
Check the scope of supply:
Completely assembled pressure switches
„
Ordered accessories
„
Inspect the pressure switch for possible damage during transportation. Should there be any
„
obvious damage, inform the transport company and SICK without delay.
Keep the packaging, as it offers optimal protection during transportation (e.g. changing
„
installation location, shipment for repair).
Ensure that the pressure connection thread and the connection contacts will not be
„
damaged.

7. Starting, operation

Required tools: wrench (flats 27), screw driver
Diaphragm test for your safety
It is necessary that before starting the pressure switch you test the instrument visual, as the
diaphragm is a safety-relevant component.
Pay attention to any liquid leaking out, for this points to a diaphragm damage.
„
Use the pressure switch only if the diaphragm is undamaged.
„
Use the pressure switch only if it is in a faultless condition as far as the safety-
„
Warning
relevant features are concerned.
28 © SICK AG • Germany • All rights reserved • Subject to change without notice 8013154/U275/2010/02/01
6. Packaging / 7. Starting, operation PBS