Display Mode; Programming Mode - SICK T&D PBS Mode D'emploi

Operating Instructions
4-digit LED display - Display system pressure
1. LED (blue)
2. LED (blue)
Operating Modes
System start

Display Mode

Programming Mode

Parameter
Parameter Description
SP1 / SP2 Hysteresis function: Switch point Switch output (1 or 2)
FH1 / FH2 Window function: Window high switch output (1 or 2)
RP1 / RP2 Hysteresis function: Reset point switch output (1 or 2)
FL1 / FL2 Window function: Window Low switch output (1 or 2)
EF Enhanced Programme Functions
RES Return the set parameter to the Factory Settings
DS1
Switch Delay Time, which must occur without interruption before any electrical signal change occurs (Q1 or
Q2)
DS2
DR1
Switch Delay Time, which must occur without interruption before any electrical signal change occurs (RP1
or RP2)
DR2
OU1 Switching Function Switching Output (1 or 2)
OU2 HNO = Hysteresis Function, normally open
HNC = Hysteresis Function, normally closed
FNO = Window Function, normally open
FNC = Window Function, normally closed
UNIT Changing Units
(If the pressure range is higher than the display range, no change of the unit is posssible
and the parameter UNIT is not shown)
8013154/U275/2010/02/01
7. Starting, operation
- Display Menu Item
- Display Parameter
- Status Switch Output 1
- Status Switch Output 2 (Optional)
- Display is fully activated for 2s
- When the pressure switch is powered up within the range of the
hysteresis, the output switch is set to „not active" by default
- normal operation, displays system pressure
- Setting Parameters
© SICK AG • Germany • All rights reserved • Subject to change without notice
PBS
GB
35