Operating Instructions
SICK-specific
Index
Name Format
(dezimal)
8 Bit
70
OU2
enumerated
8 Bit
72
UNIT
Enumeration
16 Bit
73
HI
unsigned
16 Bit
74
LO
unsigned
16 Bit
77
DS2
unsigned
16 Bit
78
DR2
unsigned
8 Bit
80
DISP
Enumeration
32 Bit IEEE 754
240
MBA
float
32 Bit IEEE 754
241
MBE
float
42
© SICK AG • Germany • All rights reserved • Subject to change without notice 8013154/U275/2010/02/01
7. Starting, operation
Access
Range
0 = „Hno" : Hysteresis
mode (SP/RP) no
1 = „Hnc" : Hysteresis
mode (SP/RP) nc
R/W
2 = „Fno" : Window
mode (FH/HL) no
3 = „Fnc" : Window
mode (FH/HL) nc
0 = bar
1 = MPa
R/W
2 = kPa
3 = PSI
4 = kg/cm²
R
0...10000
R
0...10000
R/W
0...50000 (50s)
R/W
0...50000 (50s)
0 = 1 Hz
1 = 2 Hz
R/W
2 = 5 Hz
3 = 10 Hz
R
R
Remark
„no" = „normally open",
„nc" = „normally closed"
This parameter defines the pressure measurement unit and the physical
unit of the local display. After setting this parameter the values for MBA
and MBE have to be read again since these values depend upon the
pressure unit.
Maximum pressure that was applied at the pressure switch for diagnosis.
Minimum pressure that was applied at the pressure switch for diagnosis.
Switch-on delay of Q2 in ms.
Switch-off delay of Q2 in ms.
Sets the refresh cycles of the display.
The process value "Pressure Value" is linearized such that a value of
1000 corresponds to the lower end of the measuring range (MBA) and
that a value of 9000 corresponds to the upper end of the measuring
range (MBE). Pressure values lower than the lower end of the measuring
range are transmitted as 0. Pressure values above the upper end of the
measuring range are transmitted as 10000.
The process value "Pressure Value" is linearized such that a value of
1000 corresponds to the lower end of the measuring range (MBA) and
that a value of 9000 corresponds to the upper end of the measuring
range (MBE). Pressure values lower than the lower end of the measuring
range are transmitted as 0. Pressure values above the upper end of the
measuring range are transmitted as 10000.
PBS