System Commands - SICK T&D PBS Mode D'emploi

Operating Instructions
SICK-specific
Index
Name Format
(dezimal)
Display- 8 Bit
250
Rotation enumeration
Display 8 Bit
251
Mode Enumeration
Display-
16 Bit
252 Pass-
unsigned
word
8 Bit
253 LOCK
Enumeration

System Commands

Index Value Name
2 130 Restore Factory Settings
2 163 Key Lock
2 164 Key Unlock
Reset HI and LO
2 176
values
2 177 Set pressure to zero
8013154/U275/2010/02/01
7. Starting, operation
Access Range
0 = Regular
(normal)
R/W
1 = UpsideDown
(gedreht)
0 = Act : Display value
1 = Hi: Display HI
2 = Lo: Display LO
3 = SP1 (FH1)
Display SP1 or FH1
4 = RP1 (FL1)
R/W
Display RP1 or FL1
5 = SP2 (FH2)
Display SP2 or FH2
6 = RP2 (FL2)
Display RP2 or FL2
7 = Off no Display
R/W 0...9999
0 = Unlocked
R/W
1 = Locked
Remark
Resets all SPDUs to factory settings.
Locks the display against local parameter adjustments (SPDU LOCK is set to 1).
Unlocks the display for local parameter adjustments (SPDU LOCK is set to 0).
Resets the value of the highest applied pressure (HI) to 0 and resets the value of the lowest applied
pressure (LO) to the value of the upper end of the measuring range.
Sets the output signal to its zero value.
This function is only applied when the resulting zero offset to the factory-set zero point is less than +3%
of the span.
© SICK AG • Germany • All rights reserved • Subject to change without notice
Remark
Enables electronic rotation of display by 180°.
Specifies the standard display.
Act corresponds to the actual system pressure,
HI corresponds to the maximum system pressure,
LO corresponds to the minimum system pressure.
SP1 / SP2 correspond to the switching points 1 / 2
RP1 / RP2 correspond to the reset points 1 / 2
FH1 / FH2 correspond to the upper window limits 1 / 2
FL1 / FL2 correspond to the lower window limits 1 / 2
For configurations with only one switching output the values 5 and 6 are
not used. In this case, the deactivation of the display is triggered by the
value 7 = Off.
Password that is needed to adjust the pressure switch locally. If the
password is set to 0, the user is not prompted for a password.
Locks the menu such that the programming mode can not be entered.
PBS
43