Removal; Electrical Control Unit - Burkert 2103 Manuel D'utilisation

Electrical control Unit

8.5.

removal

Danger!
risk of injury from discharge of medium and pressure!
It is dangerous to remove a device which is under pressure due to
the sudden release of pressure or discharge of medium.
• Before removing a device, switch off the pressure and vent the
lines.
procedure:
→
Loosen the pneumatic connection.
→
Remove the device.
Replacement of the diaphragm is described in the chapter
entitled "11. Repairs".
Type 2103
9. elecTrical cOnTrOl uniT
The valve Type 2103 can be combined with following control units:
• Type 8690 Pneumatic Control Unit
(actuator size ∅ 70 - ∅ 130)
• Type 8691 Control head (actuator size
• Type 8695 Control head (actuator size
• Type 8692 Positioner (
(actuator size ∅ 70 - ∅ 130)
• Type 8693 Positioner (
(actuator size ∅ 70 - ∅ 130)
• Type 8694 Positioner
(actuator size ∅ 70 - ∅ 130)
• Type 8696 Positioner (actuator size
• Type 8645 Automation system FreeLINE
• Typ e 6012 Pilot valve
• Type 6014 P Pilot valve
The electrical connection of the pilot valve or the control is
described in the respective operating instructions for the
pilot valve/control.
english
∅ 70 - ∅ 130)
∅ 50)
Position controller)
Process controller)
∅ 50)
39