Front Panel Functions - Marshall DSL100HR Mode D'emploi

FRONT PANEL FUNCTIONS

DSL40CR FRONT PANEL
1 2 3 4 5
DSL100HR FRONT PANEL
25 24 23 22
1. INPUT
Input jack socket for your guitar cable.
Use a good quality screened/shielded
guitar cable to help prevent noise
interference.
CLASSIC GAIN CHANNEL
2. GAIN
Controls the gain level for the CLASSIC
GAIN channel. As the amount of gain
increases, so will the distortion level in
your sound.
3. MODE STATUS LED
This LED lights green to indicate that
CLEAN mode is selected and red to
indicate CRUNCH mode is selected.
ENGLISH
6 7 8 9 10 11
21 20 19 18 17 16 15
4. VOLUME
Controls the volume level of the
CLASSIC GAIN channel.
5. CLEAN/CRUNCH
Press to select CLEAN or CRUNCH
mode. The CLASSIC GAIN channel's two
modes take your sound from clean to
overdriven tones.
ULTRA GAIN CHANNEL
6. GAIN
Controls the gain level for the ULTRA
GAIN channel. As the amount of gain
increases, so will the distortion level in
your sound.
12 13 14 15 16 17
14 13 12 11 10 9
7. MODE STATUS LED
This LED lights green to indicate that
OD1 mode is selected and red to
indicate OD2 mode is selected.
8. VOLUME
Controls the volume level of the ULTRA
GAIN channel.
9. OD1/OD2
Press to select OD1 or OD2 mode. The
ULTRA GAIN channel's two modes go
from an open, high gain overdrive to a
mid-boosted tone with even higher gain
possibilities.
NOTES ON USING CHANNELS AND MODES:
The channel is automatically selected when
a mode switch is pressed: Clean/Crunch or
18 19 20 21 22 23 24
8 7 6 5 4 3 2
OD1/OD2.
When you select a channel its previous
mode, FX loop and master volume settings
will be recalled.
The channel can also be selected using
the supplied 2-way footswitch. When the
2-way footswitch is connected, the front
panel mode switch (Clean/Crunch or OD1/
OD2) will be active only on the selected
channel.
Use the optional 6-way footswitch (PEDL-
91016) to switch between channels, modes
and more – see the DSL FOOTSWITCHING
section in this manual for further info.
ENGLISH
25
1