Compliance Statement - Marshall DSL100HR Mode D'emploi

WARNING! IMPORTANT SAFETY INSTRUCTIONS
WARNING:
Before going any further, make sure that
your amplifier is compatible with your
mains electricity supply. If you have any
doubt, please seek help from a qualified
technician – your Marshall dealer can
help you in this respect.
MAINS INPUT & FUSE:
The specific mains input voltage
rating that your amplifier has been
manufactured for is indicated on the
rear panel of the amplifier. Your amplifier
is provided with a detachable mains
(power) lead, which should be connected
to the MAINS INPUT socket on the rear
panel of the amplifier (Rear Panel Function
#26). The correct value and type of
mains fuse is specified on the rear panel
of the amplifier.
NEVER attempt to bypass the fuse or fit
one of the incorrect value or type.
TRANSPORTING YOUR EQUIPMENT:
Please ensure that your amplifier is
switched off, unplugged from the mains
electricity supply and all removable
cables have been disconnected from
your equipment before attempting to
move it.
IMPORTANT SET UP INFORMATION:
1. When using the DSL40CR, or the
DSL100HR with an extension
speaker cabinet(s), make sure
that the speaker cabinet(s) is
connected to the correct impedance
loudspeaker jack socket(s) on the
rear panel of the amplifier. See
the LOUDSPEAKERS guide in this
manual for specific information
regarding impedance matching (Rear
Panel Function #33).
ENGLISH
WARNING:
Failure to do the above may damage
your amplifier. When connecting a
speaker cabinet make sure that you use
a proper speaker cable. Never use a
screened (shielded) guitar cable for this
purpose.
2. Ensure that the POWER switch is
set to the OFF position (Front Panel
Function #25).
3. Ensure the OUTPUT switch is in
the STANDBY position (Front Panel
Function #24).
4. Connect the supplied mains (power)
lead into the MAINS INPUT (Rear
Panel Function #26) first and then into
an electricity outlet.
5. Ensure that the volume controls on
the front panel are set to zero (Front
Panel Functions #19 & #21).
6. Plug your guitar into the INPUT jack
socket (Front Panel Function #1).
7. Switch the amplifier ON using
the POWER switch, wait for a
few minutes and then switch the
OUTPUT switch to either the LOW
or HIGH position.
8. Turn the selected channel volume
up to your preferred level and your
amplifier is ready to play.

COMPLIANCE STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modifications not expressly approved by the party
responsible for compliance could void the users authority to operate the equipment.
This device complies with CAN ICES-3(B)/NMB-3(B)
PLEASE READ THIS MANUAL CAREFULLY
BEFORE PLUGGING IN.
FOLLOW ALL INSTRUCTIONS AND HEED ALL WARNINGS.
KEEP THESE INSTRUCTIONS.
ENGLISH