Before Use - Hilti DD-WMS 100 Mode D'emploi Original

Container capacity
Water capacity
Volumetric flow rate (air)
Water flow rate
Water pressure
4.2 Bluetooth
Frequency band
Maximum emitted transmission power
5

Before use

5.1 Filling the water and waste material container
1. Open the two catches.
2. Remove the filter bag. → page 13
3. Fill the water container with water up to the MAX mark.
When the "Water level too high" warning lamp lights, the appliance
cannot be operated.
The water and waste material container must be filled for the "Water
supply" and "Recycling" modes.
4. Insert the filter bag. → page 11
5. Fit the top section of the appliance onto the water and waste material
container.
6. Close the two catches.
5.2 Fitting the filter bag
A filter must be fitted for the Vacuum cleaner and Recycling modes.
1. Open the two catches.
2. Lift the top section of the appliance away from the water and waste
material container.
3. Attach the filter to the filter holder.
4. Fit the top section of the appliance onto the waste material container.
5. Close the two catches.
*2154324*
3
2154324
8 liq. gal
US
(32 ℓ)
14 ℓ
20 liq. gal /s
US
(74 ℓ/s)
1 liq. gal /min
US
(3 ℓ/min)
100 psi
(7 bar)
2,400 MHz ...
2,483 MHz
10 dBm
2
English 11