Hilti DD-WMS 100 Mode D'emploi Original page 19

6.2 Select mode
Mode: Using vacuum cleaner mode
▶ Set the control switch to the position
The water management system is designed to be used only for
smaller vacuum cleaning jobs, such as cleaning up the working
area. Do not use this appliance in the vacuum mode for system
applications in combination with electric tools.
Mode: Water supply mode
▶ Set the control switch to the position
▶ Open the water flow regulator on the diamond core drilling machine.
▶ The water quantity is controlled by the water flow regulator on the
diamond core drilling machine.
Mode: Recycling
▶ Set the control switch to the position
▶ Vacuum removal begins.
▶ Open the water flow regulator on the diamond core drilling machine.
▶ The water quantity is controlled by the water flow regulator on the
diamond core drilling machine.
6.3 Switching off the water management system
▶ Set the control switch to
6.4 Removing the filter bag
1. Open the two catches.
2. Lift the top section of the appliance away from the water and waste
material container.
Sharp or pointed objects that have pierced through the filter bag
may present a risk of injury. Check to ensure that the filter bag has
not been pierced by sharp or pointed objects. Carefully remove the
filter bag from the filter bag holder in the water and waste material
container.
3. Close the filter bag with the cap that's attached to the bag.
4. Remove the filter bag.
▶ Dispose of the filter bag in accordance with the applicable legal
requirements.
5. Fit the top section of the appliance onto the waste material container.
6. Close the two catches.
6.5 Emptying the waste material container
1. Open the two catches.
*2154324*
.
5
2154324
.
.
.
English 13