Personal Protective Equipment; Before Use - Hilti VC 40 Mode D'emploi

u) Never operate the appliance when it is dirty or
wet. Dust (especially dust from conductive ma-
terials) or dampness adhering to the surface of
the appliance may, under unfavorable conditions,
lead to electric shock. Dirty or dusty appliances
should thus be checked at a Hilti service center
at regular intervals, especially if used frequently
for working on conductive materials.
v) Check to ensure that the supply cord does not lie
in a puddle of water.
w) Do not use the power outlet or accessories when
the hands are wet.
5.7 Material picked up
a) Do not use the appliance to pick up flammable
or explosive dusts (magnesium or aluminium dust
etc.) or dusts which present a health hazard.
b) A vacuum cleaner of the dust class M is suitable for
picking up dry, non-flammable dusts, wood chips or
shavings and hazardous substances with an expos-
ure limit value of ≧0.1mg/m³. The vacuum cleaner
must be equipped with a filter suitable for the
hazard classification of the dusts to be picked up.
c) Do not use the appliance to pick up flammable,
explosive or aggressive liquids (coolants and lub-
ricants, gasoline, solvents, acids (pH<5), alkalis
(pH>12.5) etc.)
d) Switch the appliance off immediately if foam or
liquids escape from it.

6 Before use

CAUTION
The mains voltage must comply with the specification
given on the type identification plate. Ensure that the
appliance is disconnected from the electric supply.
DANGER
Connect the appliance
earthed/grounded power sources.
CAUTION
Always check to ensure that the vacuum cleaner is
standing securely. Engage the castor brakes.
All manuals and user guides at all-guides.com
e) Avoid contact with alkaline or acidic liquids. If
f)
g) Do not pick up objects or materials that could
5.8 Thermal
Do not use the vacuum cleaner to pick up hot mater-
ials with a temperature of over 60°C (glowing cigar-
ettes, hot ash, etc.).

5.9 Personal protective equipment

a) The user and any other persons in the vicinity
b) When working with mineral drilling slurry, wear
CAUTION
When fitting the top section of the vacuum cleaner,
take care to avoid pinching your fingers or damaging
the supply cord.
6.1 Use of extension cords and generators or
See section "Description / use of extension cords".
6.2 Operating the appliance for the first time 2
only to properly 1.
2.
contact accidentally occurs, flush with water. In
the event of the liquid coming into contact with
the eyes, rinse the eyes with plenty of water and
consult a doctor.
Wear protective gloves when using the vacuum
cleaner to pick up hot materials with a max. tem-
perature of 60°C.
cause injury by piercing through the dust bag
(e.g. pointed or sharp objects).
must wear suitable eye protection, a hard hat,
ear protection, protective gloves, safety footwear
and respiratory protection while the appliance is
in use or during servicing.
protective clothing and avoid skin contact with
the slurry (pH>9: caustic).
transformers
Open the two catches.
Lift the vacuum cleaner top section away from the
waste material container.
en
23