Symbols On The Product; Product Information; Declaration Of Conformity - Hilti DD-WMS 100 Mode D'emploi Original

1.2.3 Symbols in the illustrations
The following symbols are used our in illustrations:
These numbers refer to the corresponding illustrations found at the
beginning of these operating instructions.
The numbering reflects the sequence of operations shown in the
illustrations and may deviate from the steps described in the text.
Item reference numbers are used in the overview illustrations and
refer to the numbers used in the product overview section.
These characters are intended to specifically draw your attention to
certain points when handling the product.
1.3 Product-dependent symbols

1.3.1 Symbols on the product

The following symbols are used:
Do not transport by crane
Bluetooth (optional)

1.4 Product information

products are designed for professional users and only trained,
authorized personnel are permitted to operate, service and maintain the
products. This personnel must be specifically informed about the possible
hazards. The product and its ancillary equipment can present hazards if
used incorrectly by untrained personnel or if used not in accordance with
the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to
state the product details when contacting Hilti Service or your local Hilti
organization to inquire about the product.
Product information
Water management system
Generation
Serial no.

1.5 Declaration of conformity

We declare, on our sole responsibility, that the product described here
complies with the applicable directives and standards.
declaration issued by the certification department can be found at the end
of this documentation.
2 English
DD-WMS 100
DD-
WMS 100 BLE
01
A copy of the
2154324
*2154324*