Various Settings ("User Set") - VOLTCRAFT B6 Duo Notice D'emploi

Chargeur multiple/dechargeur

Table des Matières

Les langues disponibles

16. VARIOUS SETTINGS ("USER SET")

Both charging channels are independent from each other. If you make any settings

for charging channel 1, they do NOT apply for charging channel 2.

Therefore, you need to programme the desired settings for both charging channels.

• In the main menu, select the "USER SET" menu with the "TYPE/STOP" button.

USER SET

• Press the button "ENTER/START"; the display shows, e.g., the following:

LiPo

V.Type

Here you can select one of the three lithium battery types the charger is able to work

with ("LiPo", "LiIon", "LiFe").

• Briefly press the button "ENTER/START". The voltage value then begins to flash.

With the buttons "+" or "-", you can select the cell voltage "3.3", "3.6" or "3.7". At the same

time, the corresponding battery type changes in the top line.

Confirm the selection of the lithium battery type with the button "ENTER/START", and the

voltage value stops flashing.

The settings made here for the lithium battery type then applies for ALL other

functions, e.g. charging, discharging, etc. (see chapter 11).

• With the button "+", switch to the next setting (or to the previous one with the button "-").

LiPo/LiIo/LiFe

CHK Time

Here you can set the time in which the charger checks a connected lithium battery for

the correct cell count and terminates the charge process, if applicable.

This may be especially helpful with deep discharged batteries. For a battery with a

higher capacity set a longer time; for one with a lower capacity set a correspondingly

shorter time.

PROGRAM->

3.7V

10min

Table des Matières

Table des Matières