VOLTCRAFT B6 Duo Notice D'emploi page 91

Briefly press the button "ENTER/START". The time then begins to flash. With the buttons
"+" or "-", you can select the time (5 to 60 minutes). Save the setting with the button
"ENTER/START"; the time stops flashing.
• With the "+" button, you access the next setting (or with the button "-" the previous setting
or return to the main menu with the button "TYPE/STOP".)
NiMH Sensitivity NiMH Sensitivity
NiMH Sensitivity NiMH Sensitivity NiMH Sensitivity
D.Peak 10mV/Cell D.Peak 10mV/Cell D.Peak 10mV/Cell
D.Peak 10mV/Cell D.Peak 10mV/Cell
Here you can set the sensitivity of the delta-U detection of NiMH battery (voltage differ-
ence in the delta-U charge procedure).
A value which is too high may overcharge the battery but if the value is too low, the
battery may not be completely charged.
Briefly press the button "ENTER/START". The voltage value then begins to flash.
With the buttons "+" or "-", you can set the voltage value (5 to 20 mV). If you select
"DEFAULT", the charger uses a voltage of 7 mV.
Save the setting with the button "ENTER/START"; the voltage stops flashing.
• With the "+" button, you access the next setting (or with the button "-" the previous setting
or return to the main menu with the button "TYPE/STOP".)
NiCd Sensitivity NiCd Sensitivity
NiCd Sensitivity NiCd Sensitivity NiCd Sensitivity
D.Peak D.Peak
D.Peak
D.Peak D.Peak
Here you can set the sensitivity of the delta-U detection of NiCd batteries (voltage
difference in the delta-U charge procedure).
A value which is too high may overcharge the battery but if the value is too low, the
battery may not be completely charged.
Briefly press the button "ENTER/START". The voltage value then begins to flash.
With the buttons "+" or "-", you can set the voltage value (5 to 20 mV). If you select
"DEFAULT", the charger uses a voltage of 12 mV.
Save the setting with the button "ENTER/START"; the voltage stops flashing.
Default Default
Default
Default Default
91