VOLTCRAFT B6 Duo Notice D'emploi page 81

If the current value blinks, you can switch between manual ("Man") and automatic
("Aut") mode by simultaneously pressing the buttons "+" and "-".
In manual mode ("Man"), the batteries are charged with the current you have set.
In automatic mode ("Aut"), the charger calculates the charge current automatically;
all you do is set the top limit for the charge current. Shorter charging times can be
achieved depending on the battery and its internal resistance.
• Change the charge current (or in automatic mode the top limit for the charge current)
using the buttons "+" and "-", confirm the value using the "ENTER/START" button. The
number of cells is automatically identified!
• To begin the charging process, keep the "ENTER/START" button pressed for longer
(approx. 3 seconds).
• If the charger detects an error (e.g. no battery connected), a warning signal is emitted
and a corresponding info appears on the display.
You can stop the warning signal by pressing the "TYPE/STOP" button. You then return
to the previous configuration menu.
• If the battery is detected correctly, the following display appears, for example:
Battery type
NiMH 2.0A NiMH 2.0A
NiMH 2.0A NiMH 2.0A NiMH 2.0A
CHG 043:20 01253 CHG 043:20 01253 CHG 043:20 01253
CHG 043:20 01253 CHG 043:20 01253
Current charging duration
• Once the charging process has been completed, an audio signal is emitted.
If you wish to terminate the charging process beforehand, press the "TYPE/STOP"
button.
Charge current Battery voltage
7.42V 7.42V
7.42V 7.42V 7.42V
Charge capacity in mAh
81