Cycle Programme ("Cycle") - VOLTCRAFT B6 Duo Notice D'emploi

Chargeur multiple/dechargeur

Table des Matières

Les langues disponibles

c) Cycle Programme ("CYCLE")

To test or refresh batteries, you can perform up to 5 cycles in sequence. The two possible

combinations are "Charge/Discharge" ("CHG>DCHG") and "Discharge/Charge"

("DCHG>CHG").

• After you have selected the "NiMH" or "NiCd" program in the main menu with the button

"TYPE/STOP" and confirmed this with the button "ENTER/START", you can select the

cycle programme using the button "+" or "-" (illustration shows NiMH battery):

NiMH CYCLE

CHG>DCHG

• If you want to switch the charge/discharge sequence or set the cycle number, press the

button "ENTER/START". The text for the sequence now flashes in the bottom line of the

display.

Change the order using the buttons "+" and "-".

NiMH CYCLE

CHG>DCHG

First the battery is charged and then discharged in the left image. In the right image, this

sequence is reversed, meaning first the battery is discharged and then charged.

• Confirm the selection by pressing the "ENTER/START" button.

• Afterwards the cycle count flashes, meaning how often the presently set sequence of

charge/discharge or discharge/charge operations is performed. You can set a value from

1 to 5 cycles with the buttons "+" or "-". Confirm your entry as usual with the buttons

"ENTER/START".

• To start the cycle, keep the "ENTER/START" button pressed (approx. 3 seconds).

• If the settings are wrong, or if the charger detects a problem, an audio signal is emitted

and the appropriate information is shown on the display.

• Once the cycle is completed, an audio signal is emitted.

If you wish to terminate the cycle beforehand, press the "TYPE/STOP" button.

NiMH CYCLE

DCHG>CHG

Table des Matières

Chapitres

Table des Matières