Table Des Matières - JUKI LBH-772NV-1 Manuel D'utilisation

蠢 . SPEcIFIcATIONS .................................................................................................................1
蠡 . PREPARATION AND OPERATION ......................................................................................6
1. checking the position of the work clamp check .......................................................................................... 7
2. checking the thread trimming action (NB type) ........................................................................................... 8
3. Passing gimp through the machine head ................................................................................................... 10
4. Starting the machine and lifting the work clamp check (NB type) ............................................................ 11
5. Thread trimming (NV type) ............................................................................................................................ 12
蠱 . ADJUSTMENT ....................................................................................................................13
1. Adjusting the seam quality ........................................................................................................................... 13
(1) Adjustng the thread tenson ..................................................................................................................... 13
(2) Adjustng the thread take-up sprng . ......................................................................................................... 15
(3) Adjustng the gmp tenson ....................................................................................................................... 16
(4) Needle-to-hook tmng .............................................................................................................................. 17
2. Adjusting the thread trimming device (NB type) ........................................................................................ 18
(1) Adjustng the engagement between the gude plate lockng pn and the lockng plate . ............................ 18
(2) Adjustng the operatng depth of the pull-n plate ..................................................................................... 19
(3) Adjustng the forced returnng mechansm ............................................................................................... 21
3. Adjusting the gimp guide .............................................................................................................................. 23
(1) Adjustng the heght of gmp gude shaft actuatng rod plate .................................................................... 23
(2) Adjusting the position of the gimp guide finger . ........................................................................................ 24
(3) Adjusting the position of the gimp guide finger at the time of stop motion ............................................... 29
4. Adjusting the timing to shift the gimp position between the stitch base lines ....................................... 30
5. Replacing the moving knife and the stationary knife (NB type) ................................................................ 33
蠶 . EMERGENCy STOP ...........................................................................................................34
蠹 . WHEN OPERATING A MACHINE EqUIPPED WITH AO-17 OR AO-32 ...........................36
蠧 . TROUBLES AND CORRECTIVE MEASURES ..................................................................38
cONTENTS
xxv