Customer Mounted Accessories; Factory Fitted Accessories - socomec ATyS Série Notice D'utilisation

2. GENEraL prESENtatIoN

2.4. Customer mounted accessories

2.4.1. Bridging bars
3e 6s 6e
To connect switch I & II load terminals together.
2.4.2. Voltage sensing and power supply kit
3e 6s 6e
Allows voltage sensing and power supply connections from switch terminals to power supply and control module. Secure cables
tray, no specific cable protection required (fuse type).
2.4.3. optional modules 3e 6s 6e
• N° 1 - communication module
Control and state feedback of the changeover switch via a 2 or 3-wire RS485 link with protocol JBUS / MODBUS® and transmission
speed up to 38 400 bauds.
• N° 2 - 2 Inputs / 2 Outputs
2.4.4. Terminal shrouds (125 to 630 A)
3e 6s 6e
Incoming and outgoing protection against direct contact with the connection terminals or parts.
Cannot be mounted in the rear position at the same time as the voltage sensing and power supply kit or the brid ging bars. Can
be mounted top or bottom, in front or in rear position.
2.4.5. Terminal screens 3e 6s 6e
Incoming and outgoing protection against direct contact with the connection terminals or parts.
3e 6s 6e
2.4.6. Control voltage transformer
Transformateur 400 V~ / 230 V~.
2.4.7. Mounting spacers (125 to 630 A)
3e 6s 6e
Raises the device's terminals 10 mm away from the backplate or frame on which the device is mounted.
2.4.8. Remote interfaces ATyS d10 or d20
3e 6s 6e
• ATyS D10
Allows sources' state and switch position to be displayed remotely.
• ATyS D20
- Allows sources state and switch position to be displayed remotely.
- Allows remotely configuration, control and metering (from front panel).

2.5. Factory fitted accessories

2.5.1. Supplementary auxiliary contact (AC)
3e 6s 6e
Pre-breaking and signalling of positions I and II: 1 additional NO / NC auxiliary contact in each position.
Low level AC: please consult us.
3e 6s 6e
2.5.2. padlocking in 3 positions
Allows locking of the operation in the 3 positions I, 0 and II.
3e 6s 6e
2.5.3. handle key interlocking accessories
Locking of the electrical and the manual operation by means of a RONIS EL11AP lock.
Possibility of locking in another position, if the "Padlocking in the 3 positions" option is ordered. Not compatible with flush mounting.
ATyS 3e, 6e, 6s - Ref.: 531 848 G GB 75