socomec ATyS Série Notice D'utilisation page 116

7.3. Programming (cont.)
7.3.3. parameters characteristics (cont.)
Inputs / Outputs Menu
Menu activated in case of 2I / 2O optional module connection (up to 2 modules).
Refer to accessories mounting for Input & Output terminals identification.
In case of option re-plug or de-plug action, inspect Inputs / Outputs identification and programming.
Output relays are NO type (construction) and can not be configured as NC.
Input state can be configured: NC or NO.
LCD Denomination / Definition
Input 1
1 2
State input 1
1 2
Input 2
1 2
State input 2
1 2
Input 3
1 2
State input 3
1 2
Input4
1 2
State input 4
1 2
Output 1
1 2
Output 2
1 2
Output 3
1 2
Output 4
1 2
• Inputs:
Ft1, Ft2: External Fault 1or 2. The fault led is blinking as soon as the input is active and Ft1or Ft2 is displayed on LCD. Reset when
the input is de-activated.
PRI: Priority network selection. Network 1 has priority when input is not activated. Network 2 has priority if input is active.
This information is the only considered in case of option configuration. Programming variable Pri is then
inhibited.
Mtf: Remote manual re-transfer. Feature identical to manual re transfert on keypad. Re-transfer from priority network to standby
network is allowed from input activation (1s front). The Mtf variable in the setup menu must be selected (Yes) to allow input recognition.
Refer to priority source return sequence.
S2A: Information source 2 available (Genset) used instead of voltage / frequency measurement from ATyS (inhibited when S2A is
selected).
Refer to loss of priority source sequence.
116 ATyS 3e, 6e, 6s - Ref.: 531 848 G GB
6s 6e
1 2
7. opEratIoN atyS 6s and 6e
Setting range
Ft1, Ft2, Pri,
Mtf, S2A, /
NO, NC
Ft1, Ft2, Pri,
Mtf, S2A, /
NO, NC
Ft1, Ft2, Pri,
Mtf, S2A, /
NO, NC
Ft1, Ft2, Pri,
Mtf, S2A, /
NO, NC
S1A, S2A,
LS, /
S1A, S2A,
LS, /
S1A, S2A,
LS, /
S1A, S2A,
LS, /
Default values
/
NO
/
NO
/
NO
/
NO
/
/
/
/