Operational Modes; Programming - socomec ATyS Série Notice D'utilisation

6.2. Operational modes

6.2.1. Visualisation
Parameters and values display. No password required.

6.2.2. programming

Parameters configuration. Password access (1000 from factory).
6.2.2-1
Programming
code
Programming
Programming
code
Programming
6.3. Programming
1
Accessible in or AUT modes. Modified values are considered after mode exit.
6.3-1
navigation
or • Access parameters: press "up", "down" "left" or "right" push buttons
+
• Modify parameter value: press "right" to access parameter to modify
Press "up" and "down" to modify parameter and validate
+
• Home return: press "ESC"
If modified value is not validated, new parameters won't be taken into account
poSiTion
Visualisation
"auT" poSiTion
Visualisation
6. opEratIoN atyS 3e
Handle removed
from housing
Padlocking Manual operation
Command
not inhibited
Commands
Position I Position O
ATyS 3e, 6e, 6s - Ref.: 531 848 G GB
Position II
103