Operation Atys 3E; Presentation; Software Version - socomec ATyS Série Notice D'utilisation

6. operaTion aTyS 3e

6.1. Presentation

The product can be remotely driven in 0, I or II positions. It is equipped with two power supplies to allow self supply from sources.
The power supply and control module allows:
• product state and commands display,
• optional modules connection,
• parameters configuration.
6.1-1
CONTROL
- CONTROL led is on AUTO mode,
command not inhibited
- Leds 1 , O and 2 depend
on commands.
Switch state
2 green leds:
- switch I state
- switch II state
Led is on when switch
is closed
Yellow led (O) is on when
both switches are opened.
Padlock
Yellow led is on when product
is padlocked.
Changeover switch position indication
Position O, I or II.
Manual operation
• Insert handle
• Only possible in mode,
not padlocked.

6.1.1. Software version

Displayed after reset.
102 ATyS 3e, 6e, 6s - Ref.: 531 848 G GB
LCD
Displays:
- local/remote modes
- number of permutations
- communication activation
- source concerned by displayed information.
Keypad
LCD & leds test
6.1.1-1
FAULT led
Led is on when product
is faulty.
Disconnect power supplies
to reset.
POWER led
Green led is on when
product is powered.
Escape
Key switch (selector)
• Insert key
• Turn right for AUT mod
• Turn left for mod.
Padlock
• Only possible in 0 position (I and II optional)
• Remove handle
• Pull padlocking mechanism to allow
padlock insertion.
Product Version
number
Navigation
Validation