Operational Modes - socomec ATyS Série Notice D'utilisation

7.2. Operational modes

7.2.1. Visualisation
Measured values & parametered timers display. Always accessible without code.
7.2.2. programming
Parameters configuration. Password access (code 1000 from factory).
7.2.3. operation
Test sequences or electrical control of the position. Password access (code 4000).
7.2.3-1
Programming
Code
Programming Visualisation
Programming
Code
Programming Visualisation
* only on ATyS 6e
7.2.4. phases rotation control
This feature allows in manual mode, to verify phases rotation
before commisionning.
or
1 2 1 2
1 2
(source or source ).
1
Only source phases rotation control on ATyS 6s & on sources
1 2
and on ATyS 6e.
Function available on both sources (ATyS 6e) in case of 4NBL or 3NBL type of network and only on source
in case of 41NBL or 42NBL network (refer to annexes).
108 ATyS 3e, 6e, 6s - Ref.: 531 848 G GB
Operation
Code
Operation
Test off load
poSiTion
Control I, O, II*
Position Position Position
I O
displayed according to faulty source
7. opEratIoN atyS 6s and 6e
poSiTion
Phases
rotation
control
"auT"
Operation
Code
Operation
Test off load Test on load
II
7.2.4-1
V1
V3
Handle not
in place
Manual
Padlocking
emergency
operation
Loss of
Main's return
main source
sequence
sequence
V1
OK
V2 V2
PROT
V3
1