Safety Instructions Relating Specifically To The Equipment - Meister MTS710-1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
MW-5451520-Bedien-1610 05.10.16 08:31 Seite 33
persons unfamiliar with the power
tool or these instructions to
operate the power tool. Power tools
are dangerous in the hands of
untrained users.
• Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
• Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
Service
• Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This
will ensure that the safety of the
power tool is maintained.
6 – Safety instructions
relating specifically to
the equipment
• Hold the tool by the insulated handle
surfaces when carrying out tasks
during which is it possible that the
screw will come across hidden
power cables or its own cable. If the
screw comes into contact with a live
cable, this will connect the metal parts
of the machine to voltage and result in
electrical shock.
• Wear eye and ear protectors.
• Before driving screws into a wall
check – if possible, using a mains
detector – that you are not driving
screws into an electricity cable or a
gas or water pipe.
• When operating the machine, avoid
allowing the motor to stop under
load.
• Select a speed that will not cause the
screw tips to overheat.
• To avoid hazards, damaged power
leads must be replaced by the
manufacturer or his customer service
representative.
Safety symbols
The symbols on the housing have the
following meanings:
Do not dispose of with the
household waste!
Important! Observe the
operating instructions!
Wear goggles.
Wear a dust protection
mask.
Wear ear defenders.
The housing is double
insulated
33

Publicité

Table des Matières
loading

Table des Matières