Quick Set-Up Guide - Numatic TTB 4045/100 Mode D'emploi

!
After the removal of all the packaging, carefully open and check the contents.
1
2
3
4
Fig.7
5
Fig.8
PLEASE READ BEFORE COMMENCING ANY OPERATION.
Ensure the Batteries are charged before use.
Using the handle position lever
(Fig.1), move the handle into the
upright position (Fig.2).
Fig.1
Place 50 amp fuse (supplied in the accessory kit) into the fuse holder using
the Maxi Fuse puller provided (Fig.3).
(Fig.4) Shows 50 amp fuse.
Fig.3
Place the top tank (waste water) into the machine (Fig.5) and connect the
vacuum
Fig.5
Fit the isolator key and switch the machine on (Fig.7).
Fill the bottom tank (Clean Water) from a tap or hose pipe using the Flexi-Fill pipe fitted to
the filler cap (Fig.8). Add non-foaming cleaning fluid as required (See page 30).
The TTB 4045 / TTB 4055 and the ETB 4045 all have a water capacity of 40 Litres.
and floor-tool hose to the separator (Fig.6).
Note:
Great care must be taken to ensure that contaminants
(leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the filling process.
If using a bucket or similar, ensure it is always clean
and free from debris.
20

Quick Set-Up Guide

!
Fig.2
Fig.4
Fig.6