Pre-Scrub Mode; Floor-Tool In Use; Break Away Floor-Tool Feature; Machine Operation - Numatic TTB 4045/100 Mode D'emploi

Pre-scrub mode

The TTB / ETB Range has been designed to cope with a variety of floor types and different levels of soiling.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor-tool in the raised position, allow the chemical time to work, then scrub the area a
second time with the floor-tool lowered.
Ref to (Fig.18) to raise and lower the floor-tool.
Floor tool in use
Breakaway floor-tool
Note Care must be taken to reduce speed when cornering or when manoeuvring around obstacles.
Note: The machine will still reverse with the floor-tool in the lowered position, this could possibly damage the
blades. Raise the floor-tool before reversing.
The clean-water / chemical mix is dispersed via 'THRU-FEED' system.
The waste water is then retrieved by the floor-tool.
Overlap the scrubbing path by 10cm to ensure an even clean (Fig.23).
Fig.23
If streaking occurs,
wipe the floor-tool
blades clean
(Fig.24).
Fig.24
The floor-tool design incorporates a breakaway feature.
Allowing it to safely disengage from its mounting should it
become caught on an obstruction, during forward machine
movement (Fig.26).
To re-attach the blade to its holder.
First loosen the retaining knobs on the floor-tool body and slide
onto the holding bracket.
Tighten retaining knobs to finger tight.
Fig.26

Machine Operation

32
Fig.25