Quick Set-Up Guide - Numatic TTB 4045/100 Mode D'emploi

!
After the removal of all the packaging, carefully open and check the contents.
1
2
3
4
Fig 7
5
Fig 8
PLEASE READ BEFORE COMMENCING ANY OPERATION.
Ensure the Batteries are charged before use.
Using the handle position lever
(Fig 1), move the handle into the
upright position. (Fig 2).
Fig 1
Place 50 amp fuse (supplied in the accessory kit) into the fuse holder using
the Maxi Fuse puller provided (Fig 3).
(Fig 4) Shows 50 amp fuse.
Fig 3
Place the top tank (waste water) into the machine (Fig 5) and connect the
YDFXXP DQG ÀRRU WRRO KRVH WR WKH VHSDUDWRU )LJ  
Fig 5
Fit the isolator key and switch the machine on (Fig 7).
)LOO WKH ERWWRP WDQN &OHDQ :DWHU IURP D WDS RU KRVH SLSH XVLQJ WKH )OH[L)LOO SLSH ¿WWHG WR
WKH ¿OOHU FDS )LJ   $GG 1RQ IRDPLQJ FOHDQLQJ ÀXLG DV UHTXLUHG 6HH SDJH  
The TTB 4045 / TTB 4055 and the ETB 4045 all have a water capacity of 40 Litres.

Quick Set-Up Guide

Note:
Great care must be taken to ensure that contaminants
(leaves, hair, dirt, etc.) are not allowed to enter the
FOHDQZDWHU WDQN GXULQJ WKH ¿OOLQJ SURFHVV
If using a bucket or similar, ensure it is always clean
and free from debris.
20 20
!
Fig 2
Fig 4
Fig 6